Diagnostic Aids and Remove Procedure for the Ready Fuser Life Message – Xerox Phaser 6280 and 6280MFP
The Ready Fuser Life message happens as a result of the fuser nearing the end of its life. The fusing assembly, Xerox Phaser 6280 and 6280MFP FUSER ASSEMBLY – 675K70595has an average life of 100,000. There is a chip inside the fusing unit that measures the usage. Once this chip reaches the end of its life the machine will fail to work unless the fusing unit is replaced. The ready fuser life message is a pre warning message to let you know its time to get one on order. Failure to do so will result in unwanted downtime. Not really a lot more to say about this problem. I listed the removal instructions below and troubleshooting tips. With that being said 99% of the time replacing the fuser will fix your issue. So get yourself a fuser, replace it, and keep your printer running.
â– Chain Link 010-421: IOT Fuser Life Pre Warning
1. Open the Front Cover.
2. Open the Duplex Gate Chute.
3. Release the Gray levers on the left and right sides of the Fuser to unlock the Fuser from the printer.
4. Push the Fuser toward the front, and lift the Fuser up to remove it.
Service Manual Troubleshooting Tips for the Ready Fuser Life Message
1. Check the Fuser life using CentreWare IS.
Does the Level show 0%?
Replace the Fuser
2. Check the Fuser for correct installation.
Is the Fuser correctly installed?
Reseat the Fuser
3. Does the error still occur?
Replace the Fuser
4. Does the error still occur?
Replace the MCU Board
For further pricing options and details click on the link below for more information.
Xerox Phaser 6280 and 6280MFP FUSER ASSEMBLY – 675K70595