Ready Fuser Life, Fuser Life Pre Warning – Xerox Phaser 6280 and 6280MFP

 

Diagnostic Aids and Remove Procedure for the Ready Fuser  Life Message – Xerox Phaser 6280 and 6280MFP

The Ready Fuser  Life message happens as a result  of the fuser nearing the end of its life. The fusing assembly, Xerox Phaser 6280 and 6280MFP  FUSER  ASSEMBLY – 675K70595has an average life of 100,000. There is   a chip inside the fusing unit that measures the usage. Once this chip reaches the end of its life the machine will fail to work unless the fusing unit is replaced. The ready fuser  life message is a pre warning message to let you know its time to get one on order. Failure to do so will result in unwanted downtime. Not really a lot more to say about this problem. I listed the  removal instructions below and troubleshooting tips. With that being said 99% of the time replacing the fuser  will fix your issue. So get yourself a fuser, replace it, and keep your printer running.

â–  Chain Link 010-421: IOT Fuser Life Pre Warning

Ready Fuser Life Message - Xerox Phaser 6280 and 6280MFP photo

1. Open the Front Cover.
2. Open the Duplex Gate Chute.
3. Release the Gray levers on the left and right sides of the Fuser  to unlock the Fuser from the printer.
4. Push the Fuser  toward the front, and lift the Fuser up to remove it.
 

Service Manual Troubleshooting Tips for the Ready Fuser Life Message

1. Check the Fuser  life using CentreWare IS.
Does the Level show 0%?
Replace the Fuser
2. Check the Fuser for correct installation.
Is the Fuser correctly installed?
Reseat  the Fuser
3. Does the error still occur?
Replace the Fuser
4. Does the error still occur?
Replace the MCU Board
 
For further pricing options and details click on the link below for more information.
Xerox Phaser 6280 and 6280MFP  FUSER  ASSEMBLY – 675K70595

We will be happy to hear your thoughts

Leave a reply

Shopping cart