Replace Fuser Soon (Fuser End of Life) Xerox Phaser 6180 and 6180 MFP

 

Tips For Resolving The Replace Fuser  Soon Message on the Xerox Phaser 6180 and 6180MFP

Replacement of the fusing assembly, Xerox Phaser 6180, 6180MFP  Fuser  Assembly – 675K92001 , is very important in these models when the replace fuser soon message is displayed to avoid unwanted down time. Inside these  fusing assembly  is a chip that reads the usage of the unit. Once the unit has reached its maximum number of prints then the machine will stop working until the fusing unit is replaced. Below is information on getting into service mode so you can check the fuser  life counter, instructions on the fuser removal, and further troubleshooting tips if you have an ongoing issue after the  fusing unit  has been replaced.

â–  Chain Link 010-421: IOT Fuser  Life Pre Warning (Fuser End of Life)

Entering Service Diagnostics
1. Turn the printer power Off.
2. Press and hold the Up and Down Arrow buttons simultaneously and turn the printer power On.
3. Please wait… message is displayed.
4. Continue to hold the buttons until the Service Mode message is displayed on the Control Panel and release the buttons.
5. Select the appropriate option to perform diagnostics procedures.
6. Enter Printer Diag  
7. Scroll down to the Parameter Menu
8. Scroll to the Fuser Life counter and verify it’s near the end of its life.

Troubleshooting Procedure Table
1. Check the Fuser for correct installation.
2. Is the Fuser correctly installed?
3. Reseat  the Fuser.
Does the error still occur?
4. Replace the Fuser.
Does the error still occur?
5. Replace the MCU Board

Replace Fuser Soon Xerox Phaser 6180 and 6180 MFP photo

Xerox Phaser 6180, 6180MFP  Fuser  Assembly – 675K92001 Removal Procedure
Warning : The Fuser  may be hot. Turn the printer power Off and allow at least 5 minutes for the Fuser  to cool before removing the Fuser.
1. Open the Front Cover.
2. Open the Duplex Gate Chute (PL6.1.13).
3. Release the levers on the left and right sides of the Fuser  to unlock the Fuser from the printer.
4. Lift the green latches, push the Fuser  toward the front, and lift the Fuser up to remove it.

For pricing options and more details click on the link below for more information.
Xerox Phaser 6180, 6180MFP  Fuser  Assembly – 675K92001

We will be happy to hear your thoughts

Leave a reply

Shopping cart