Canon imageRUNNER 1730iF E010 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E010 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E010 0001 Error Code
E010 0001
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100 msec since the start of drive and there had been no lock detection signal in 2 seconds.
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Bear in mind, not every error is absolutely alike. What remedies the malfunction one occasion might not get rid of it the next time. While the content in this page obtain from the service manual and usually ought to get your unit ready to go, at times other elements can be in play.
If you are looking at this piece of content and have expertise in this fault and would wish to share please leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have exposure to the trouble then I will answer back.
