Canon imageRUNNER 1730iF E804 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E804 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E804 0000 Error Code
E804 0000
Description :
Power Supply Cooling Fan (FM4) error
Causes :
A lock signal was detected for 5 seconds while the Power Supply Cooling Fan (FM4) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Power Supply Cooling Fan (FM4).
3. Replace the DC Controller PCB (PCB1).
Bear in mind, not every error is totally alike. What corrects the malfunction one occasion may not solve it the next occasion. While the details in this article is obtained from the service manual and usually ought to get your product up and running, in some cases other variables might be in play.
If you are looking at this short article and have information about this problem and wish to make a contribution please make sure to leave a comment down below. Or, if you have read this article and have more questions then ask. If I have exposure to the difficulty then I will answer back.
