Canon imageRUNNER 1730iF E530 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E530 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E530 8001 Error Code
E530 8001
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to move from the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Bear in mind, not every error is precisely alike. What treats the trouble one time may possibly not eliminate it the next occasion. While the content in this blog post is taken from the service manual and most often ought to get your piece of equipment working, now and again other factors might be in play.
If you are looking at this post and have knowledge about this malfunction and wish to contribute you should leave a comment below. Or, if you have read this article and have more questions then ask. If I have information about the problem then I will reply.
