Canon imageRUNNER 1730iF E537 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E537 8002 Error Code
E537 8002
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Bear in mind, not every error is precisely the same. What corrects the condition one time may possibly not solve it the next occasion. While the specifics in this piece of content hails from the service manual and generally should get your equipment operating, on occasion other reasons might be in play.
If you are looking at this short article and have experience with this error and want to contribute be sure to leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the difficulty then I will reply.
