Canon imageRUNNER 1730 E575 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E575 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E575 8002 Error Code
E575 8002
Description :
Gripper Motor (M7) error
Causes :
The gripper unit does not leave the gripper unit home position when the Gripper Motor (M7) has been driven for 3.8 seconds.
Solutions :
1. Check the connector connection of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
3. Replace the Gripper HP Sensor (S7).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Always remember, not every error is simply identical. What corrects the situation one occasion will possibly not solve it the next occasion. While the info in this post is taken from the service manual and most often should get your piece of equipment operational, from time to time additional factors can be in play.
If you are looking at this document and have knowledge about this fault and would wish to share please leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have information about the situation then I will respond.
