Canon imageRUNNER 1730 E804 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E804 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E804 0001 Error Code
E804 0001
Description :
Error in rotation of the Power Supply Cooling Fan (FM4)
Causes :
A lock signal could not be detected for 5 seconds while the Power Supply Cooling Fan (FM4) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Power Supply Cooling Fan (FM4).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is simply the same. What treats the situation one occasion will possibly not fix it the next time. While the material in this post obtain from the service manual and in most cases ought to get your equipment ready to go, from time to time additional variables might be in play.
If you are looking at this page and have expertise in this fault and would wish to share make sure you leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have exposure to the issue then I will answer.
