Canon imageRUNNER 1730 E537 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E537 8002 Error Code
E537 8002
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Always remember, not every error is simply alike. What fixes the situation one time might not get rid of it the next occasion. While the advice in this document is inspired by the service manual and in most cases should get your piece of equipment working, sometimes other causes might be in play.
If you are looking at this document and have information about this problem and would like to make a contribution you should leave a comment below. Or, if you have read this article and have further questions then ask. If I have information about the problem then I will reply.
