Canon imageRUNNER 1730 E010 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E010 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E010 0002 Error Code
E010 0002
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100msec during the drive (after the lock detection) and the lock signal was not detected 5 times in a row (in 500 msec).
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is absolutely the same. What remedies the complication one occasion might not remedy it the next occasion. While the content in this piece of content is taken from the service manual and generally ought to get your product operational, occasionally other variables may be in play.
If you are looking at this article and have exposure to this fault and desire to share be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the issue then I will answer.
