Canon imageRUNNER 1730 E001 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E001 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E001 0002 Error Code
E001 0002
Description :
Detection of overheating of Fixing Assembly
Causes :
The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Always remember, not every error is absolutely identical. What corrects the trouble one time might not remedy it the next occasion. While the advice in this text derives from the service manual and in most cases ought to get your equipment operating, in some cases other variables can be in play.
If you are looking at this article and have expertise in this error and would wish to make a contribution you should leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have experience with the trouble then I will reply.
