Canon imageRUNNER 2545I E110 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E110 0003 Error Code
E110 0003
Description :
Causes :
The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed.
* The same condition is detected after the error retry is performed.
Solutions :
1.Check the cable.
2.Replace the Laser Scanner Unit.
3.Replace the DC Controller PCB (PCB4).
Note, not every error is simply the same. What fixes the difficulty one occasion may not resolve it the next occasion. While the help and advice in this blog originates from the service manual and generally should get your piece of equipment functioning, sometimes additional variables may be in play.
If you’re looking at this article and have knowledge of this fault and would like to contribute please make sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have experience with the issue then I will answer.
