Canon imageRUNNER 1750iF E110 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E110 0003 Error Code
E110 0003
Description :
Laser Scanner Motor error
Causes :
The speed lock signal of the Laser Scanner Motor never showed lock status although 6.5 seconds (when switching from low speed to normal speed) or 8 seconds (when switching from normal speed to low speed) have passed.
When the same status was detected again after executing an error retry.
Solutions :
1. Check the Laser Scanner Unit connector.
2. Replace the Laser Scanner Unit.
3. Replace the DC Controller PCB (PCB1).
Make sure you remember, not every error is completely the same. What remedies the difficulty one time will possibly not take care of it the next time. While the data in this write-up is obtained from the service manual and normally ought to get your piece of equipment ready to go, in some cases other things could possibly be in play.
If you are reading this page and have information about this fault and want to share make sure you leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have information about the problem then I will reply.
