Canon imageRUNNER 1750 E010 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E010 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E010 0002 Error Code
E010 0002
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100msec during the drive (after the lock detection) and the lock signal was not detected 5 times in a row (in 500 msec).
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is simply alike. What remedies the difficulty one occasion might not resolve it the next time. While the tips in this post is taken from the service manual and usually should get your product operating, at times other causes can be in play.
If you are looking over this write-up and have exposure to this error message and want to share be sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the difficulty then I will answer back.
