Canon imageRUNNER 1740iF E822 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E822 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E822 0003 Error Code
E822 0003
Description :
Error in rotation of the Delivery Cooling Fan (Center) (FM2)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is precisely identical. What treats the condition one time will possibly not eliminate it the next occasion. While the info in this page obtain from the service manual and in most cases ought to get your piece of equipment operational, occasionally other reasons could possibly be in play.
If you are looking over this short article and have knowledge of this error message and would wish to contribute please be sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have experience with the difficulty then I will respond.
