Canon imageRUNNER 1740iF E537 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E537 8002 Error Code
E537 8002
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Just remember, not every error is completely the same. What treats the issue one time might not resolve it the next occasion. While the content in this blog post originates from the service manual and typically ought to get your device operating, on occasion additional circumstances may be in play.
If you are looking over this post and have knowledge of this fault and would like to make a contribution please leave a comment down below. Or, if you have read this article and have further questions then ask. If I have experience with the trouble then I will reply.
