Canon imageRUNNER 1740iF E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is precisely identical. What fixes the complication one time may possibly not fix it the next occasion. While the details in this write-up derives from the service manual and most likely should get your unit working, sometimes other elements may be in play.
If you are looking over this short article and have knowledge about this malfunction and wish to make a contribution please leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have information about the issue then I will reply.
