Canon imageRUNNER 1740iF E820 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E820 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E820 0003 Error Code
E820 0003
Description :
Error in rotation of the Developing Cooling Fan (Rear) (FM8)
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is exactly the same. What treats the situation one occasion will possibly not take care of it the next occasion. While the details in this text obtain from the service manual and normally should get your equipment working, now and again additional circumstances might be in play.
If you are looking over this short article and have knowledge about this error and desire to make a contribution be sure to leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have knowledge about the difficulty then I will respond.
