Canon imageRUNNER 1740iF E820 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E820 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E820 0002 Error Code
E820 0002
Description :
Developing Cooling Fan (Rear) (FM8) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is exactly the same. What remedies the issue one occasion might not solve it the next occasion. While the help and advice in this blog is obtained from the service manual and in most cases should get your device functioning, now and again other things could possibly be in play.
If you are looking over this short article and have information about this malfunction and would like to contribute make sure you leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have information about the difficulty then I will answer back.
