Canon imageRUNNER 1740 E822 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E822 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E822 0000 Error Code
E822 0000
Description :
Delivery Cooling Fan (Front) (FM3) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Front) (FM3) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Front) (FM3).
3. Replace the DC Controller PCB (PCB1).
Don’t forget, not every error is entirely alike. What fixes the trouble one time might not get rid of it the next occasion. While the content in this blog comes from the service manual and in most cases ought to get your piece of equipment operational, now and again other factors could possibly be in play.
If you are looking over this page and have exposure to this error and would wish to contribute please leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have experience with the problem then I will reply.
