Canon imageRUNNER 1740 E577 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E577 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E577 8002 Error Code
E577 8002
Description :
Paddle Motor (M3) error
Causes :
The Paddle Motor (M3) was driven for 2 seconds, but the Paddle could not be detected by the Paddle HP Sensor (S3).
Solutions :
1. Check the connector connection of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
2. Check for open circuit of the Harness of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
3. Replace the Paddle HP Sensor (S3).
4. Replace the Paddle Motor (M3).
5. Replace the Finisher Controller PCB.
Don’t forget, not every error is absolutely the same. What remedies the problem one time might not exactly fix it the next occasion. While the details in this short article hails from the service manual and most often ought to get your product working, in some cases other causes can be in play.
If you are looking over this document and have exposure to this problem and would like to share please leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have exposure to the situation then I will reply.
