Canon imageRUNNER 1740 E537 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E537 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E537 8001 Error Code
E537 8001
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Do not forget, not every error is totally the same. What treats the difficulty one time might not exactly resolve it the next time. While the tips in this article is taken from the service manual and normally ought to get your unit working, sometimes additional variables can be in play.
If you are looking over this document and have expertise in this error message and would like to share please leave a comment down below. Or, if you have read this article and have further questions then ask. If I have experience with the problem then I will answer back.
