Canon imageRUNNER 1740 E202 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E202 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E202 0000 Error Code
E202 0000
Description :
CIS home position detection error
Causes :
1. Error when moving to the left side for HP check operation
2. Error when moving to the right side for HP check operation
Solutions :
1. Disconnect and then connect the Flexible Cable (Reader Controller PCB (PCB3) – Main Controller PCB (PCB2) 31pin).
2. Replace the Flexible Cable.
3. Replace the CIS HP Sensor (PS24).
4. Replace the Reader Motor (M10).
5. Replace the Reader Controller PCB (PCB3).
6. Replace the Main Controller PCB (PCB2).
Do not forget, not every error is exactly the same. What remedies the situation one occasion may not take care of it the next occasion. While the specifics in this posting is obtained from the service manual and typically ought to get your device operational, at times other factors might be in play.
If you are looking over this article and have information about this fault and want to contribute you should leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have information about the difficulty then I will reply.
