Canon imageRUNNER 1730iF E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730iF E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730iF E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Do not forget, not every error is completely alike. What remedies the malfunction one time will possibly not take care of it the next time. While the help and advice in this short article originates from the service manual and generally should get your unit up and running, in some cases other elements may be in play.
If you are looking at this write-up and have exposure to this fault and would wish to make a contribution please be sure to leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have information about the difficulty then I will answer back.
