Canon imageRUNNER 1730 E820 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E820 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E820 0002 Error Code
E820 0002
Description :
Developing Cooling Fan (Rear) (FM8) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Always remember, not every error is totally identical. What remedies the complication one occasion may possibly not eliminate it the next occasion. While the details in this article hails from the service manual and in most cases ought to get your piece of equipment functioning, on occasion other reasons can be in play.
If you are looking at this page and have exposure to this malfunction and desire to share make sure you leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the difficulty then I will answer back.
