Canon imageRUNNER 1730 E202 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1730 E202 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1730 E202 0000 Error Code
E202 0000
Description :
CIS home position detection error
Causes :
1. Error when moving to the left side for HP check operation
2. Error when moving to the right side for HP check operation
Solutions :
1. Disconnect and then connect the Flexible Cable (Reader Controller PCB (PCB3) – Main Controller PCB (PCB2) 31pin).
2. Replace the Flexible Cable.
3. Replace the CIS HP Sensor (PS24).
4. Replace the Reader Motor (M10).
5. Replace the Reader Controller PCB (PCB3).
6. Replace the Main Controller PCB (PCB2).
Always remember, not every error is entirely identical. What corrects the malfunction one occasion might not fix it the next occasion. While the data in this document obtain from the service manual and in most cases ought to get your piece of equipment up and running, on occasion additional variables may be in play.
If you are looking at this blog post and have exposure to this error message and would like to contribute please leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have exposure to the issue then I will answer back.
