Canon-imageRUNNER-3025N E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3025N E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon-imageRUNNER-3025N E248 0000 Error Code
E248 0000
Description :
The backup memory is faulty.
Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up
Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.
If you’re looking at this article and have expertise in this fault and wish to make a contribution please be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will reply.
Note, not every error is exactly the same. What corrects the condition one time may possibly not fix it the next occasion. While the guidance in this short article is inspired by the service manual and most likely should get your piece of equipment operating, from time to time other elements could possibly be in play.
