Canon imageRUNNER 1750iF E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Make sure you remember, not every error is precisely alike. What corrects the situation one time may possibly not eliminate it the next time. While the material in this written piece originates from the service manual and oftentimes ought to get your machine up and running, now and again other elements could possibly be in play.
If you are reading this piece of content and have knowledge about this malfunction and want to contribute be sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will answer back.
