Canon imageRUNNER 1750iF E530 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E530 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E530 8001 Error Code
E530 8001
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to move from the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Make sure you remember, not every error is exactly the same. What remedies the malfunction one time might not get rid of it the next occasion. While the details in this short article comes from the service manual and oftentimes ought to get your device operational, now and again additional variables may be in play.
If you are reading this piece of content and have knowledge about this error message and wish to contribute be sure to leave a comment below. Or, if you have read this article and have additional questions then ask. If I have exposure to the problem then I will answer back.
