Canon imageRUNNER 1750iF E530 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E530 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E530 8002 Error Code
E530 8002
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to be detected by the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 0.78 seconds.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Make sure you remember, not every error is exactly the same. What remedies the trouble one occasion may not solve it the next occasion. While the data in this page is taken from the service manual and oftentimes should get your equipment ready to go, from time to time additional variables might be in play.
If you are reading this piece of content and have knowledge about this fault and wish to make a contribution please be sure to leave a comment below. Or, if you have read this article and have additional questions then ask. If I have information about the situation then I will respond.
