Canon imageRUNNER 1740iF E820 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E820 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E820 0000 Error Code
E820 0000
Description :
Developing Cooling Fan (Front) (FM7) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Front) (FM7) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Front) (FM7).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is exactly identical. What fixes the condition one time might not take care of it the next time. While the help and advice in this written piece hails from the service manual and typically ought to get your piece of equipment up and running, at times additional variables may be in play.
If you are looking over this short article and have exposure to this fault and would wish to share you should leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have exposure to the difficulty then I will reply.
