Canon imageRUNNER 1740 E575 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740 E575 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740 E575 8002 Error Code
E575 8002
Description :
Gripper Motor (M7) error
Causes :
The gripper unit does not leave the gripper unit home position when the Gripper Motor (M7) has been driven for 3.8 seconds.
Solutions :
1. Check the connector connection of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
3. Replace the Gripper HP Sensor (S7).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Don’t forget, not every error is absolutely alike. What remedies the trouble one occasion may not fix it the next time. While the material in this writing is taken from the service manual and in most cases should get your unit operating, from time to time other reasons could possibly be in play.
If you are looking over this document and have exposure to this error message and want to share be sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will respond.
