Canon-imageRUNNER-3045 E748 1001 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3045 E748 1001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3045 E748 1001 Error Code
E748 1001
Description :
There is a mismatch between controller board and SDRAM size.
Causes :
There is a mismatch between the control board and the SDRAM.
Solutions :
Check the correct combination between board and SDRAM.
If you’re looking over this write-up and have knowledge of this malfunction and wish to contribute you should leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the issue then I will answer back.
Take into account, not every error is absolutely the same. What corrects the malfunction one time may not fix it the next occasion. While the information in this article is obtained from the service manual and typically should get your piece of equipment up and running, now and again additional variables might be in play.
