Canon imageRUNNER 2545 E532 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E532 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545 E532 0001 Error Code
E532 0001
Description :
Causes :
The stapler does not leave the stapler move home position when the STP Move Motor (M1) has been driven for 0.25 sec.
Solutions :
1.Replace the Stapler Move HP Sensor (S10).
2.Check the wiring between the Finisher Controller PCB and the STP Move Motor.
3.Check the stapler shift base.
4.Replace the STP Move Motor (M1).
5.Replace the Finisher Controller PCB (PCB1).
Please remember, not every error is exactly identical. What corrects the situation one time might not resolve it the next occasion. While the material in this writing obtain from the service manual and most often should get your product functioning, at times additional factors might be in play.
If you’re looking at this page and have exposure to this fault and would wish to contribute please be sure to leave a comment below. Or, if you have read this article and have further questions then ask. If I have exposure to the situation then I will answer back.
