Canon imageRUNNER 2545 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545 E261 0000 Error Code
E261 0000
Description :
Causes :
Zero Cross failed to be detected for 500ms or more while the relay was ON.
* The same condition is detected after the error retry is performed.
Solutions :
1.Check the Connectors.
2.Replace the DC Controller PCB (PCB4).
Please remember, not every error is precisely the same. What corrects the malfunction one time may not get rid of it the next occasion. While the guidance in this blog comes from the service manual and normally ought to get your piece of equipment functioning, in some cases other things can be in play.
If you’re looking at this piece of content and have experience with this fault and would like to make a contribution please leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will reply.
