Canon imageRUNNER 2545 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545 E248 0000 Error Code
E248 0000
Description :
Causes :
1.An error has occurred at power-on.
2.An error has occurred during write operation.
3.An error has occurred during read operation following write operation.
Solutions :
1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 50pin).
2.Disconnect and then connect the flexible cable(CCD unit- Relay PCB (PCB2)).
3.Disconnect and then connect the power supply harness connector.
4.Replace the flexible cable.
5.Replace the CCD Unit.
6.Replace the Relay PCB (PCB2).
7.Replace the Power Supply PCB (PCB3).
8.Replace the Main Controller PCB (PCB1).
Please remember, not every error is precisely the same. What remedies the trouble one time will possibly not get rid of it the next time. While the information in this writing is obtained from the service manual and normally ought to get your device operating, at times other reasons may be in play.
If you’re looking at this piece of content and have experience with this malfunction and desire to contribute please leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the difficulty then I will answer.
