Canon imageRUNNER 2535I E805 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E805 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535I E805 0001 Error Code
E805 0001
Description :
Causes :
1.When lock signal failed to be detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is driven.
2.When lock signal failed to be detected for 5 sec while the Finisher Fan 1 (M8) is driven.
3.When lock signal failed to be detected for 5 sec while the Finisher Fan 2 (M9) is driven.
* The same condition is detected after the error retry is performed.
Solutions :
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the Finisher Fan 1 (M8).
4.Replace the Finisher Fan 2 (M9).
5.Replace the DC Controller PCB (PCB4).
Realize, not every error is completely the same. What treats the complication one time may not take care of it the next occasion. While the data in this post comes from the service manual and generally ought to get your product operating, at times other elements can be in play.
If you’re looking at this post and have knowledge about this problem and want to contribute be sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will answer back.
