Canon imageRUNNER 2535I E805 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E805 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535I E805 0000 Error Code
E805 0000
Description :
Causes :
When lock signal is detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is stopped.|* The same condition is detected after the error retry is performed.
Solutions :
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the DC Controller PCB (PCB4).
Realize, not every error is entirely alike. What fixes the situation one occasion might not solve it the next time. While the material in this short article is obtained from the service manual and generally should get your unit working, in some cases other factors can be in play.
If you’re looking at this post and have knowledge about this problem and would wish to share make sure you leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the problem then I will answer back.
