Canon imageRUNNER 2535 E531 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E531 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E531 8001 Error Code
E531 8001
Description :
Causes :
The stapler does not leave the staple home position when the Staple Motor (M10) has been driven for 0.5 sec.
Solutions :
1.Check the wiring between the Finisher Controller PCB and Stapler.
2.Replace the Stapler.
3.Replace the Finisher Controller PCB (PCB1).
Remember that, not every error is exactly identical. What corrects the problem one time will possibly not take care of it the next time. While the details in this document comes from the service manual and most likely ought to get your piece of equipment functioning, from time to time additional circumstances can be in play.
If you’re looking over this document and have knowledge about this error and would like to share please be sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have knowledge about the issue then I will answer.
