Canon imageRUNNER 2535 E000 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E000 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E000 0001 Error Code
E000 0001
Description :
Causes :
The temperature detected by the main thermistor does not rise to the specified value during startup control.
Solutions :
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember, not every error is absolutely the same. What remedies the issue one occasion may not remedy it the next time. While the information in this writing hails from the service manual and normally ought to get your device operational, sometimes other things might be in play.
If you’re looking over this piece of content and have exposure to this problem and desire to share make sure you leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the difficulty then I will respond.
