Canon imageRUNNER 1750iF E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Make sure you remember, not every error is totally identical. What treats the condition one time will possibly not resolve it the next occasion. While the help and advice in this post comes from the service manual and in most cases should get your equipment ready to go, from time to time additional circumstances could possibly be in play.
If you are reading this post and have knowledge of this error and want to make a contribution please leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the difficulty then I will reply.
