Canon imageRUNNER 1750iF E001 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E001 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E001 0002 Error Code
E001 0002
Description :
Detection of overheating of Fixing Assembly
Causes :
The Sub Thermistor detected 295 deg C or higher for 200msec or longer on end.
Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).
Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95
from: Precision Roller
Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset
Canon imageRUNNER 1730 Fuser Removal and Replacement
Make sure you remember, not every error is absolutely identical. What corrects the complication one occasion may not take care of it the next occasion. While the material in this page originates from the service manual and oftentimes should get your machine functioning, occasionally other things can be in play.
If you are reading this document and have knowledge of this problem and want to contribute make sure you leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have knowledge about the trouble then I will reply.
