Canon imageRUNNER 1750 E822 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E822 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E822 0002 Error Code
E822 0002
Description :
Delivery Cooling Fan (Center) (FM2) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Keep in mind, not every error is simply the same. What corrects the complication one occasion may possibly not fix it the next time. While the details in this blog is inspired by the service manual and typically ought to get your equipment functioning, occasionally other variables may be in play.
If you are reading this document and have information about this malfunction and would like to share you should leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have experience with the trouble then I will reply.
