Canon imageRUNNER 1740iF E575 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E575 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E575 8002 Error Code
E575 8002
Description :
Gripper Motor (M7) error
Causes :
The gripper unit does not leave the gripper unit home position when the Gripper Motor (M7) has been driven for 3.8 seconds.
Solutions :
1. Check the connector connection of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper HP Sensor (S7) or the Gripper Motor (M7).
3. Replace the Gripper HP Sensor (S7).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Just remember, not every error is entirely alike. What remedies the complication one occasion might not remedy it the next occasion. While the data in this short article obtain from the service manual and in most cases ought to get your piece of equipment functioning, from time to time additional variables can be in play.
If you are looking over this post and have knowledge of this problem and desire to contribute please make sure to leave a comment below. Or, if you have read this article and have further questions then ask. If I have experience with the problem then I will respond.
