Canon imageRUNNER 1740iF E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Just remember, not every error is completely the same. What fixes the problem one time may possibly not eliminate it the next occasion. While the data in this document originates from the service manual and oftentimes ought to get your unit operating, now and again other variables can be in play.
If you are looking over this post and have knowledge of this error and want to make a contribution please be sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will answer back.
