Canon-imageRUNNER-4570 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-4570 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-4570 E003 0000 Error Code
E003 0000
Description :
The fixing temperature is too low after a standby state.
Causes :
While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1293-020 Fuser (Fixing) Unit – 120 Volt (Genuine) – $599.95
Canon imageRUNNER 4570 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 4570 E000, E001, E002, E003, Error Code Reset
If you’re reading this page and have knowledge of this error message and would wish to contribute be sure to leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have exposure to the difficulty then I will answer.
Try to remember, not every error is exactly alike. What fixes the difficulty one occasion may not eliminate it the next occasion. While the help and advice in this text obtain from the service manual and usually ought to get your device operating, now and again additional variables may be in play.
