Canon-imageRUNNER-3030 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3030 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3030 E003 0000 Error Code
E003 0000
Description :
The fixing temperature is too low after a standby state.
Causes :
While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1293-020 Fuser (Fixing) Unit – 120 Volt (Genuine) – $599.95
Canon imageRUNNER 3030 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 3030 E000, E001, E002, E003, Error Code Reset
If you’re looking at this document and have knowledge about this malfunction and would wish to make a contribution please be sure to leave a comment below. Or, if you have read this article and have additional questions then ask. If I have information about the situation then I will reply.
Please remember, not every error is entirely the same. What corrects the difficulty one time might not exactly eliminate it the next time. While the information in this post originates from the service manual and typically ought to get your product ready to go, occasionally additional variables might be in play.
