Canon-imageRUNNER-2270 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-2270 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-2270 E003 0000 Error Code
E003 0000
Description :
The fixing temperature is too low after a standby state.
Causes :
While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1278-000 Fuser (Fixing) Unit – 120 Volt (Genuine) – $549.95
Canon imageRUNNER 2270 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 2270 E000, E001, E002, E003, Error Code Reset
If you are looking at this piece of content and have knowledge about this problem and would like to share please leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have experience with the trouble then I will answer back.
Bear in mind, not every error is completely the same. What corrects the complication one time may possibly not resolve it the next time. While the ideas in this document is obtained from the service manual and generally ought to get your device ready to go, in some cases other factors can be in play.
