Canon imageCLASS D1170 E001 0 Error Code Instructions
Below you will find the service manual information for the Canon imageCLASS D1170 E001 0 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageCLASS D1170 E001 0 Error Code
E001 0
Description :
E001 0 Abnormally high temperature (detected by main thermistor)
Causes :
The main thermistor detected an abnormally high temperature during temperature control.
Solutions :
Check the connector of the fixing film unit.
Replace the fixing film unit.
Replace the Engine controller PCB.
HP RM1-6405-000cn Fuser (Fixing) Unit – 120 Volt (Genuine) – $129.95
Canon imageCLASS D1170 Fuser Removal and Replacement RM1-6405-000, FM4-3436-000
Make sure you remember, not every error is absolutely identical. What corrects the condition one occasion might not exactly take care of it the next occasion. While the information in this blog post originates from the service manual and usually ought to get your piece of equipment operational, in some cases other reasons may be in play.
If you’re looking over this post and have experience with this error and wish to contribute you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will reply.
